Arris C4C - Configure Access-List Remark

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1208
configure access-list * remark
Purpose
Associates a comment with an existing ACL. To clear or remove the specified comment, use the no option.
Default Access Level
15
Command Syntax
configure access-list <num> remark ["text of remark"]
configure access-list <num> remark ["text of remark"] no
Supplemental
Information
The remark text must be in quotes unless it is a single word.
If the no option is used, the command describing the access list entry will be removed.
Parameters
<num>
The access-list-number. This is a number from 1-99; the extended access-list-number is 100-199.
["text of remark"]
Comment that describes the access list entry. The remark text should be in quotes. Valid range is up to 100 characters.