Arris C4C - Accounting Method Lists; Common CLI Commands for AAA Using TACACS

Chapter 29: Security
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 846
 Configuration information includes the list’s name and an ordered list of authorization methods (TACACS+, local, and
none). (There are two independent lists for console and vty authorization, plus one additional list for testing
configuration changes).
 By default, no authorization method lists exist; the default configuration does not contain authentication method list
configuration information.
 Authorization method list configuration information persists across system reboots and power-cycles.
Accounting Method Lists
Accounting may be assigned to one or more TACACS+ server groups or to the local logging function of the C4/c CMTS. As
with authentication and authorization, accounting may be assigned to multiple methods in order of preference such that
method n+1 is employed if method n is is not available. This ordered list of methods is referred to as an accounting method
list.
The C4/c CMTS supports six independently configurable accounting method lists. The accounting method lists have the
following characteristics:
 Configuration information includes the list’s name and an ordered list of accounting methods (TACACS+, local, and
none) (four independent lists for console and vty shell and command accounting, plus two additional lists for testing
configuration changes).
 By default, no accounting method lists exist; the default configuration does not contain authentication method list
configuration information.
 Accounting method list configuration information persists across system reboots and power-cycles.
Common CLI Commands for AAA Using TACACS
Use the following command to configure TACACS+ servers and TACACS+ server groups. Each server may be configured with
an IP address, shared secret, TCP port number, and timeout value. Each group may be configured with a group name and
one or more TACACS+ servers. All hosts are automatically assigned to the TACACS+ server group named tac_default.
Note: This TACACS+ tac_default group will not exist until a configure tacacs host command has been completed
(i.e., there is no empty group with this name).
configure tacacs {group string host ipAddress | host ipAddress [key string] [port integer] [timeout
integer] [single-connection]} [source-interface][no]