Arris C4C - Configure Pagination

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2232
configure pagination
Purpose
Displays a number of lines of consecutive CLI output and then will pause at the bottom of the screen and give you the option to load
another page of information or to quit.
Default Access Level
15
Command Syntax
configure pagination
configure pagination no
Supplemental
Information
A value of zero indicates no pagination. Non-zero values are only applicable for transports that do not support window size
negotiation (serial, ssh). Transports which support window size negotiation (telnet) may override this parameter.
To disable pagination and display CLI output all at once, use the no option.
Related Commands
configure line vty (page 2175)
terminal length (page 3057)
show running-config interface cable-downstream (page 3023)