Arris C4C - Configure Arp State Searching Global-Max-Rate

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1238
configure arp state searching global-max-rate
Purpose
Sets the maximum number of ARP requests per second transmitted for an ARP entry in the searching state.
Default Access Level
15
Command Syntax
configure arp state searching global-max-rate <0-65535>
configure arp state searching global-max-rate [<0-65535>] no
Supplemental
Information
After this number is reached, the next request causes the entry to transition to the notPresent state.
To reset the maximum number of ARP request per second to the default value, use the no option.
Parameters
<0-65535>
Rate is in packets/second for ARPs.
Related Commands
configure arp state not-present max-time (page 1233)
configure arp state not-present max-time (page 1233)
configure arp state not-present rate-limit (page 1235)
configure arp state searching max-number (page 1239)