Arris C4C - Configure Snmp-Server Card-Trap-Inh Slot

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2534
configure snmp-server card-trap-inh slot
Purpose
Sets the card trap inhibit bits(s) for the linecard.
Default Access Level
15
Command Syntax
configure snmp-server card-trap-inh slot <slot> <value>
Supplemental
Information
N/A
Parameters
<0-20>
Chassis slot number
<value>
Trap inhibit status value. This is a one-byte hexadecimal value.
80 is used to inhibit the primary trap
40 is used to inhibit the secondary trap
20 is used to inhibit the duplex trap
10 is used to inhibit the detected trap
08 is used to inhibit the temperature out of range trap
04 is used to inhibit the temperature no report trap
02 is used to inhibit the temperature overheat trap
(example: c0 = 80 + 40 — primary and secondary trap are inhibited)