Chapter 31: Load Balancing
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 896
registration-steeringD2 – enable moving any D2.0 CMs registering on a TDMA channel to an ATDMA channel in the
load balance group via DCC.
registration-steeringD3 – enable moving the primary US channel of any D3.0 CMs registering on a TDMA channel to an
ATDMA channel in the load balance group via DCC.
periodic-steeringD2 – enable moving D2.0 CMs to an ATDMA channel in the load balance group.
periodic-steeringD3 – enable moving the primary US channel of D3.0 CMs to an ATDMA channel in the load balance
group.
disable-period – specifies when a rule is inactive.
The following apply to load balancing rules:
Each rule may be enabled, fully disabled, or disabled for a particular period each day independently of the load
balancing group’s enable/disable state.
Multiple load balancing rules may be assigned to an individual load balancing policy.
A load balance rule may be referenced by multiple policies.
A default rule, which is only assigned to the default policy (0), contains the following default values:
Table 112. Default Rule Values
static and non-bonded-dcc
To Next Page
Loading...
