Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1470
configure interface cable-downstream * cable channel-id
Configures the channel identifier for the specified downstream.
configure interface cable-downstream <slot/port> cable channel-id <int>
Note: Downstream must be in a cable-mac before executing this command. The logical channel and cable-mac must be
shutdown before you can change the channel-id.
Parameters
The chassis slot in which the targeted downstream Cable Access Module resides. Valid range for the C4 CMTS is 0-15; valid range for
the C4c CMTS is 10-15.