Arris C4C - Configure Interface Link-Aggregate Ipv6 Nd Prefix

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1896
configure interface link-aggregate * ipv6 nd prefix
Purpose
Sets the lifetime prefixes for the IPv6 advertisements.
Default Access Level
15
Command Syntax
configure interface link-aggregate <0-9[.0-254]> ipv6 nd prefix <word> [<valid_lifetime>]
[<preferred_lifetime> [off-link] [no-autoconfig] [autoconfig]
configure interface link-aggregate <0-9[.0-254]> ipv6 nd prefix <word> [<valid_lifetime>]
[<preferred_lifetime> [off-link] [no-autoconfig] [autoconfig] no
Supplemental
Information
To remove the prefix from the advertisements, use the no option.
Parameters
<0-9[.0-254]>
LAG identifier <lag[sub interface]>
<word>
IPv6 address
<valid_lifetime>
Valid lifetime in seconds.
<preferred_lifetime
>
Preferred lifetime in seconds.
[off-link]
Indicates prefix is not locally reachable by hosts and must be routed.
[no-autoconfig]
Indicates that the host may not use prefix for auto-configured IPv6 addresses.
[autoconfig]
Indicates that the host may use prefix for auto-configured IPv5 addresses.