Arris C4C - Display Qos for CM IP Address (Verbose)

Chapter 38: Per-Subscriber Throughput
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1016
Current Throughput : 822096 bits/sec, 99 packets/sec
Required Attribute Mask : 0x00000000
Forbidden Attribute Mask : 0x00000000
Attribute Aggregate Rule Mask : 0x00000000
Sfid : 16
Direction : DS
Current State : Active
Sid : 0
Traffic Priority : 0
Peak rate : 0 bits/sec
Maximum Sustained rate : 0 bits/sec
Maximum Burst : 96000 bytes
Minimum Reserved Rate : 0 bits/sec
Minimum Packet Size : 16 bytes
Admitted QoS Timeout : 200 seconds
Active QoS Timeout ` : 0 seconds
Maximum Latency : 0 usecs
Current Throughput : 822096 bits/sec, 99 packets/sec
Required Attribute Mask : 0x00000000
Forbidden Attribute Mask : 0x00000000
Attribute Aggregate Rule Mask : 0x00000000
Display QoS for CM IP Address (Verbose)
The following command is an example to display verbose QoS information and verify throughput settings by using a
specific CM’s IP address:
show cable modem qos 10.142.31.238 verbose
An output similar to the following is returned by the system:
Sfid : 15
Direction : US
Current State : Active
Sid : 8199
Traffic Priority : 0
Peak Rate : 0 bits/sec
Maximum Sustained Rate : 0 bits/sec
Maximum Burst : 16128 bytes
Minimum Reserved Rate : 0 bits/sec
Minimum Packet Size : 16 bytes
Admitted QoS Timeout : 200 seconds
Active QoS Timeout : 0 seconds
Maximum Concatenated Burst : 16128 bytes
Scheduling Type : Best Effort
Request/Transmission Policy : 0x00000000