Arris C4C - Show Running-Config Interface Link-Aggregate

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 3028
show running-config interface link-aggregate
Purpose
The show running-config interface command shows the parameters for the specified link-aggregate interface.
Default Access Level
15
Command Syntax
show running-config interface link-aggregate <0-9[.0254]> [verbose] [linenum] [full]
Supplemental
Information
N/A
Parameters
<0-9[.0-254]>
LAG identifier <lag[sub interface]>
[verbose]
Displays the output with ‘configure’ on each line.
[linenum]
Enumerates each line with its line number in the output.
[full]
Displays all configuration values, including default values.