Arris C4C - Tools Required; Recommended Torque Values in Inch-Pounds

Chapter 4: C4 CMTS General Installation Requirements
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 96
Completed (X)
Task Description
Attach to DC power (See see "Power (page 79))
Attach cables
Connect an operator console
Power up the C4 CMTS
Configure the C4 CMTS according to the instructions in Basic Bring-up Procedure for the C4 CMTS (page
325)
1
CAMs are client modules; the SCM and RCM are system modules.
Tools Required
The following tools are required for installation:
 #3 Phillips screwdriver for large bolts
 #2 Phillips screwdriver
 Digital volt meter
 Torque wrench
Torque Values
The following table lists the recommended torque values for selected screws and fasteners of the C4 CMTS.
Table 10. Recommended Torque Values in Inch-pounds
Fasteners
Torque
Screws for grounding cable
10.0 +/- 0.5 in-lbs.
Captive fasteners of PCMs
5.0 +/- 0.5 in-lbs.
Captive fasteners of Fan Trays
5.0 +/- 0.5 in-lbs.