Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2421
configure router bgp * neighbor * update-source loopback
Configures the first neighbor command for a neighbor who is not directly connected.
configure router bgp [<int>] neighbor <ipv6> update-source loopback <0-63>
The IP address of the specified neighbor by the update-source option is used by the other routes to reference the C4 CMTS in their
neighbor commands. If the initial neighbor command does not contain the update-source, then the other routers will reference us
by the directly connected physical interface on the C4 CMTS.
Note: We do not allow the update-source to be specified after a neighbor is created.
Parameters
Autonomous System (AS) number. Valid range is 1-65535
The Loopback interface number.
To Next Page
Loading...
