Arris C4C - Display Debug Information

Chapter 41: Logging
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1042
7 6(notice)
8 6(notice)
9 6(notice)
10 6(notice)
11 6(notice)
12 6(notice)
13 6(notice)
14 6(notice)
15 6(notice)
Display Debug Information
The show logging debug command assists with troubleshooting certain facilities of the system. The following command
example displays a typical debug output:
show logging debug
An output similar to the following will occur:
Debug: rip.authentication enabled on all slots
rip.daemon.down enabled on all slots
rip.daemon.started enabled on all slots
rip.daemon.stopped enabled on all slots
rip.daemon.up enabled on all slots
rip.general.general enabled on all slots
rip.general.ifdatanotfound enabled on all slots
rip.general.message enabled on all slots
rip.general.route enabled on all slots
rip.interface.added enabled on all slots
rip.interface.removed enabled on all slots
rip.message.receivedisabled enabled on all slots
rip.message.senddisabled enabled on all slots
rip.msgrcvd.error enabled on all slots
rip.msgrcvd.request enabled on all slots
rip.msgrcvd.response enabled on all slots
rip.msgsent.request enabled on all slots
rip.msgsent.response enabled on all slots
rip.msgsent.socketerror enabled on all slots
rip.msgsent.triggeredupdate enabled on all slots
rip.route.added enabled on all slots
rip.route.advertise enabled on all slots
rip.route.error enabled on all slots
rip.route.filtered enabled on all slots
rip.route.invalid enabled on all slots
rip.route.invalidated enabled on all slots