Arris C4C - Configure Interface Tengigabitethernet Isis Authentication Key-Chain

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2044
configure interface tengigabitethernet * isis authentication key-chain
Purpose
Configures the IS-IS authentication for LSPs.
Default Access Level
15
Command Syntax
configure interface tengigabitethernet <slot>/<port>[.<0-254>] isis authentication key-chain <name>
[<level-1 | level-2>]
configure interface tengigabitethernet <slot>/<port>[.<0-254>] isis authentication key-chain <name>
[<level-1 | level-2>] no
Supplemental
Information
Note: All commands that include key-chains required that the key-chain already exists before the command is executed. In addition,
the key-chain should not be deleted until after the command(s) that reference it have been reset with the "no" command.
To reset the circuit type, use the no option.
Parameters
<slot>/<port>[.<0-
254>]
RCM slot number/tengigabitEthernet port number[.subinterface number].
Valid range for the C4 CMTS is <17-18>/<10>[.<0-254>]
Valid range for the C4c CMTS is <17>/<10>[.<0-254>]
<name>
Name of the key-chain
[<level-1 | level-2>]
Specifies the type of adjacencies to be formed on this interface. Valid range is level-1 or level-2.