Arris C4C - Configure Ipv6 State Not-Present

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2147
configure ipv6 state not-present
Purpose
Sets the rate in packets/second of ICMPv6 unreachables transmitted for all non-present IPs.
Default Access Level
15
Command Syntax
configure ipv6 nd state not-present {global-max-rate <0-65535> | max-number <0-65535> | max-time <1-
604800> | min-time <1-604800> | rate-limit <100-86400000>}
configure ipv6 nd state not-present {global-max-rate [<0-65535>] | max-number [<0-65535>] | max-time
[<1-604800>] | min-time [<1-604800>] | rate-limit [<100-86400000>]} no
Supplemental
Information
To reset to the default, use the no option.
Parameters
global-max-rate <0-
65535>
Maximum ICMP transmit rate for all non present IPv6’s
max-number <0-
65535>
Maximum number of ICMP6s sent in this state
max-time <1-
604800>
Maximum time, in seconds, in this state while actively receiving traffic
min-time <1-
604800>
Minimum time, in seconds, in this state while actively receiving traffic
rate-limit <100-
86400000>
Minimum time, in msec, between ICMP6’s