Arris C4C - Configure Cable Spectrum-Group Trigger Improvement

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1435
configure cable spectrum-group trigger * improvement
Purpose
Creates a performance trigger.
Default Access Level
15
Command Syntax
configure cable spectrum-group trigger <trigger_id> improvement [fec_err <threshold1>] [ufec_err
<threshold2>] [snr <threshold3>]
configure cable spectrum-group trigger <trigger_id> improvement [fec_err <threshold1>] [ufec_err
<threshold2>] [snr <threshold3>] no
Supplemental
Information
To delete the performance trigger, use the no option.
Parameters
<trigger_id>
The trigger number and has values of 1-64
<threshold1>
The percentage of FEC codewords with FEC errors (corrected and uncorrected) in units of one thousandth of a percent and has
values ranging from 0 to 100000. The default value is 100000.
<threshold2>
The percentage of FEC codewords with uncorrected errors in units of one thousandth of a percent and has values ranging from 0 to
100000. Default value is 100000.
<threshold3>
The maximum SNR value for the current state in tenths of a dB. Default value is 0.