To Next Page

To Previous Page

Chapter 46: Command Line Descriptions

STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide

configure interface cable-downstream * cable load-balance group

Purpose

Adds a downstream channel to the specified restricted load-balance group.

Default Access Level

Command Syntax

configure interface cable-downstream <slot/port> cable load-balance group <group>

configure interface cable-downstream <slot/port> cable load-balance group <group> no

Supplemental

Information

Note: A system must have at least one fiber-node configured before you can create, configure, and assign any restricted load-

balance groups to any interface. To successfully execute this command, you must:

1. Create one fiber node

configure cable fiber-node <abc>

2. Create a restricted load-balance group (RLBG)

configure interface cable-mac 1 cable load-balance group 10

3. Assign RLBG to an interface (e.g. where 5/0 is in cable-mac 1):

configure interface cable-downstream <slot/port> cable load-balance group 10

To remove a downstream channel from the specified restricted load-balance group, use the no option.

Parameters

<slot>

The chassis slot in which the targeted downstream Cable Access Module resides. Valid range for the C4 CMTS is 0-15; valid range for

the C4c CMTS is 10-15.

<port>

The downstream port.

<group>

Unsigned integer. Valid range is 1-8388607.

Related Commands

show cable load-balance group (page 2663)

Arris C4C User Manual

Questions and Answers: