Arris C4C - Configure Router Ospf Area Nssa

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2483
configure router ospf * area * nssa
Purpose
Configures an area as a not so stubby area (NSSA). This area allows for generation of type-7 LSAs.
Default Access Level
15
Command Syntax
configure router ospf [vrf <name>] area <area-id) nssa [no-summary]
configure router ospf [vrf <name>] area <area-id) nssa no
Supplemental
Information
These LSAs may be converted to type-5 LSAs at the Area Border Router (ABR). The default-parameter option is set when a type-7
default LSA should be generated for the NSSA.
To remove an area as a not so stubby area (NSSA), use the no option.
Parameters
[vrf <name>]
Name of the assigned VRF.
<area-id>
Identifier for the stub or NSSA area. The identifier can be specified as either an IP address or decimal value.
[no-summary]
When router is an NSSA ABR and you want the redistribute command to import routes only into normal areas, but not into the NSSA
area