Arris C4C - Basic Command Set for Bringing up a 12 U CAM; Example of Basic Command Sequence for Configuring 12 U in Slot 3

Chapter 9: Upstream Cable Access Modules (UCAMs)
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 274
1.6 MHz
3.2 MHz
6.4 MHz
16
19
22
17
20
23
18
21
24
19
22
25
20
23
26
21
24
27
22
25
28
23
26
29
Basic Command Set for Bringing Up a 12U CAM
The set of commands provided in the table below is the bare minimum for bring up a 12U CAM in a given slot. The values
chosen for these commands are meant to be examples. Actual values will vary.
Table 38. Example of Basic Command Sequence for Configuring a 12U in Slot 3
Purpose
CLI Command
Configure the Upstream Parameters
Provision slot 3 as a 12U slot.
configure slot 3 type 12UCAM
Restore 12U in slot 3.
configure slot 3 no shutdown
Assign MAC domain
configure interface cable-mac 1
Restore cable-mac 1
configure interface cable-mac 1 no shutdown
Assign a channel to cable-mac 1
configure interface cable-upstream 3/0 cable
cable-mac 1