To Next Page

To Previous Page

Chapter 12: Basic Bring-up Procedure for a C4c CMTS

STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide

---------------------------------------------------------------- ----- -------------------

Total 5 5 0 0 0 100%

For the status of the cable modems, enter:

show cable modem

An example of the show cable modem output:

C4# show cable modem

Sep 30 14:49:16

Interface DOC

(DS-US) Mac Bonded State SIS Qos CPE MAC address IP Address

------------- ----- ------ ----------- --- ------------- --- --------------- ----------------------

15/0-10/0 1 Operational 2.0 0/0 0 0015.a463.22e8 192.168.180.85

15/0-10/0 1 Operational 2.0 0/0 0 0015.ce64.3e28 192.168.180.88

15/0-10/0 1 4x1 Operational 3.0 0/0 0 0015.ce92.d1cc 192.168.180.205

15/1-10/0 1 Operational 2.0 0/0 0 0015.ce64.3999 192.168.180.110

15/2-10/0 1 Operational 2.0 0/0 0 0015.a463.2135 192.168.180.86

15/3-10/0 1 Operational 2.0 0/0 0 0015.a463.240e 192.168.180.98

15/3-10/0 1 Operational 2.0 0/0 0 0015.ce64.3e6a 192.168.180.102

Total Oper Disable Init Offline

---------------------------------------------------------

Total 7 7 0 0 0

To display the service groups, enter:

show cable service-group

An example of the show cable service-group output:

show cable service-group

Cable

MAC mCMsg mDSsg mUSsg

--- ----- ----- -----

1 2 1 1

IPv6 Configuration (Optional)

This section assigns the IPv4 subnets and IPv6 prefixes that will be configured in the CMTS. IP subnets and prefixes can be

configured to use IPv6. This allows the operator to run either IPv4 or IPv6 or both protocols simultaneously in a chassis.

Arris C4C User Manual

Questions and Answers: