Arris C4C - Traceroute Ipv6

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 3080
traceroute ipv6
Purpose
Determines the path a packet takes to get to a destination.
Default Access Level
1
Command Syntax
traceroute ipv6 <ipv6 address> [max-ttl <int>] [source <ipv6 address>] [timeout <sec>] [probe-count
<int>] [min-ttl <int>] [port-number <int>] [tos <int>]
Supplemental
Information
N/A
Parameters
<ipv6 address>
IP address used to source the traceroute
[max-ttl <int>]
Specifies the max number of hops to the destination. Range is 1 to 64 hops. Default is 30.
[source <ipv6
address>]
IP address traceroute from
[timeout <sec>]
Specifies the timeout in seconds for each ICMP echo request "probe". Range is 1 to 100 seconds. Default is 3.
[probe-count <int>]
Specifies the number of "probes" to send at each TTL level. The range is 1 to 10 probes. Default is 3.
[min-ttl <int>]
Specifies the starting TTL for the traceroute (first probe). This is used to start the traceroute beyond the known hops en
route to the desti\-nation. Range is 1 to 64 hops. Default is 1.
[port-number <int>]
Specifies the starting destination port number. The port number increments by 1 for each "probe". Range is 1 to 65535.
Default is 33434.
[tos <0 | 0-255>]
Differentiated Service Class (TOS) field type of service [0] [0-255]. Default is 0.