Arris C4C User Manual

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2511
configure router rip * distribute-list * out
Purpose
Configures filtering for outbound RIP routes.
Default Access Level
15
Command Syntax
configure router rip [vrf <name>] distribute-list <access_list_number> out <cable-mac <mac> |
gigabitethernet <slot/port> | link-aggregate <0-9[.0-254]> | tengigabitethernet <slot/port>
configure router rip [vrf <name>] distribute-list <access_list_number> out <cable-mac <mac> |
gigabitethernet <slot/port> | link-aggregate <0-9[.0-254]> | tengigabitethernet <slot/port> no
Supplemental
Information
To disable the RIP output distribution list, use the no option.
Parameters
[vrf <name>]
Name of the assigned VRF.
<access_list_
number>
Access list number (1-99)
bgp
Filters RIP routes originating from BGP.
connected
Filters RIP routes originating from a connected source
cable-mac <mac>
Filters RIP routes originating from a cable-mac interface. The MAC identifier. Valid numbers are 0-415.
gigabitethernet
<slot>/port>
RCM slot number/gigabitEthernet port number.
Valid range for the C4 CMTS is <17-18>/<0-9>
Valid range for the C4c CMTS is <17>/<0-9>
isis
Filters RIP routes originating from IS-IS.
link-aggregate
<0-9[.0-254]>
LAG identifier <lag[sub interface]>

Arris C4C Specifications

General

Brand	Arris
Model	C4C
Category	Control Unit
Language	English