Arris C4C - Sample Show Commands

Chapter 15: Interface IP Configuration
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 453
Purpose or Description
Command
show ipv6 route [vrf <WORD>] [include-inactive] [detail] link-
aggregate <WORD>
Indicate that the gigabitEthernet link is in a LAG
show interface gigabitEthernet <>
show port status <>
Indicate that the gigabitEthernet link is in a LAG
show port status network
In addition to showing membership in a LAG, the
output shows whether or not the dataplane is
passing traffic (i.e., some sort of LACP summary
state).
show ip interface gigabitEthernet <>
In addition to showing membership in a LAG, the
output of this command shows whether or not
the dataplane is passing traffic (i.e., some sort of
LACP summary state).
show ipv6 interface gigabitEthernet <>
The CLI includes the LACP throttle value and the
LACP packets received and packets dropped
counts to the output for this command.
show proto-throttle-rate
The CLI includes a new ipv6 ping command that
will specify the LAG.
ping ipv6 <WORD> [repeat-count <INT>] [source <WORD>] [timeout
<INT>] [size <INT>] [tos <INT>] [ttl <INT>] [payload <WORD>]
[validate] output-interface link-aggregate <WORD>
Sample Show Commands
Sample outputs of the most commonly used show commands will be provided.
show interface link-aggregate 1
link-aggregate 1 AdminState:Up OperState:IS
LACP: Enabled Min-links: 1
Member Ports: 17/2 17/3 17/4 17/5
Description:
Physical Address: 0001.5c24.8e82
MTU is 1500
Inbound access list is not set
Outbound access list is not set