Arris C4C - CLI Commands for ISIS; List of Commands Related to IS-IS and MT IS-IS

Chapter 16: Dynamic Routing Protocols
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 487
VRF Name IP Route Dest. Act PSt Next Hop Metric Protocol Dist Route Age Interface
=============== ================== === === =============== ====== ======== ==== ============ =============
default 4.4.4.0/24 Yes IS 10.85.9.1 30 isis(L1) 115 0 00:11:39 gigE 17/9.0
default 3.3.3.0/24 Yes IS 10.85.9.1 30 isis(L1) 115 0 00:11:39 gigE 17/9.0
By adding the "ipv6" parameter to the command, the IPv6 IS-IS route information will be displayed:
show ipv6 route isis
The system output would look similar to the following:
Codes: (L1) internal level-1, (L2) internal level-2, (eL1) external level-1,
(eL2) external level-2 (S) summary, (IA) inter-area,
(E1) external type-1, (E2) external type-2, (I) internal,
(E) external
ACT Active-IS, IS Inactive-IS, OOS Inactive-OOS
Dist/
IPv6 Route Dest / mask Act Next Hop Metric Protocol RouteAge Interface
====================== === ============================= ======= ========= ======== ===========
2001:1111:2222:3333/64 ACT fe80::20b:45ff:feb6:100 115/20 isis(L1) 00:10:52 gigE 17/9.0
2001:1234:0:3::/64 ACT fe80::20b:45ff:feb6:100 116/10 isis(L2) 00:08:07 gigE 17/9.0
2001:1234:0:4::/64 ACT fe80::20b:45ff:feb6:100 116/10 isis(L2) 00:08:07 gigE 17/9.0
2002:2001:3001:3002/64 ACT fe80::20b:45ff:feb6:100 y 115/20 isis(L1) 00:10:52 gigE 17/9.0
CLI Commands for ISIS
The following table lists many of the CLI commands that are used in configuring and managing both MT IPv4 (ID #0) and
MT IPv6 (ID #2) routing.
For more information on these CLI commands see Command Line Descriptions.
Table 66. List of Commands Related to IS-IS and MT IS-IS
Purpose
Command
Clears the IS-IS counters.
clear isis counters
Enables [disables] IS-IS routing for IPv4 / IPv6
on the specified interface.
Note: the loopback interface is always passive.
configure interface cable <WORD> ip router isis [no]
configure interface cable <WORD> ipv6 router isis [no]
configure interface cable-mac <WORD> ip router isis [no]
configure interface cable-mac <WORD> ipv6 router isis [no]
configure interface loopback <INT> ip router isis [no]
configure interface loopback <INT> ipv6 router isis [no]
configure interface gigabitethernet <WORD> ip router isis [no]
configure interface gigabitethernet <WORD> ipv6 router isis [no]