Arris C4C - Commands Related to Partial Service

Chapter 22: Channel Bonding
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 714
11/2- 4/11.0 13 4x4 4x1 U4/4.0 badTcs 3.0 0015.cfb4.5741 10.101.30.255
+11/2- 4/11.0 13 4x4 4x1 U4/5.0 badTcs 3.0 0015.cfb4.5741 10.101.136.253
+11/2- 4/11.0 13 4x4 4x1 U4/10.0 badTcs 3.0 0015.cfb4.5741 10.101.136.254
Table 90. Commands Related to Partial Service
Purpose
CLI Command
Enable the signaling of the CM-Status Event reporting
mechanism for a cable MAC.
configure interface cable-mac * cable cm-status enabled
Configure an event type via the CM-STATUS message.
configure interface cable-mac * cable cm-status event-type enabled
Configure the holdoff timer used by the CM when
determining when to transmit a CM-STATUS message.
configure interface cable-mac * cable cm-status event-type
max-event-holdoff
Configure the maximum number of reports for a
single or all event types.
configure interface cable-mac * cable cm-status event-type
max-num-reports