Arris C4C - Configure Access-List Icmp

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1198
configure access-list * icmp
Purpose
Configures an extended Access Control List (ACL) on the CMTS if the protocol value is ICMP.
Default Access Level
15
Command Syntax
configure access-list {<100-199> | <name>} <1-2147483647> <permit | deny> icmp <src-ip> <dst-ip> [dscp
<0-63>] [precedence <uint>] [tos <0-15>] [fragments] [<icmp-type> [<icmp-code>]]
configure access-list {<100-199> | <name>} <1-2147483647> <permit | deny> icmp <src-ip> <dst-ip> [dscp
<0-63>] [precedence <uint>] [tos <0-15>] [fragments] [<icmp-type> [<icmp-code>]] no
Supplemental
Information
To remove an extended ACL, use the no option.
Parameters
<100-199>
The extended ACL numeric identifier of the access list. This is a number from 1-99.
<name>
Access list name
<1-214748364>
Access list index number.
<permit | deny>
permit: Permits access if the condition is matched.
deny: Denies access if the condition is matched.
icmp
If the protocol value is ICMP, the CMTS will support the additional optional parameter string [icmp-type [icmp-code]]. ICMP packets
can be filtered by ICMP message types. The type is a number from 0 to 255. ICMP packets that are filtered by the ICMP message
type can also be filtered by the ICMP message code. The code is a number from 0 to 255.
<src-ip>
This can be the {host <IP> | any | <IP> [mask]}
<dst-ip>
This can be the {host <IP> | any | <IP> [mask]}
[dscp <0-63>]
Match packets with given DSCP value. Valid values are: