Arris C4C - Configure Interface Loopback Ipv6 Address

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1946
configure interface loopback * ipv6 address
Purpose
Enables ARP forwarding for this virtual router interface.
Default Access Level
15
Command Syntax
configure interface loopback <0-15> ipv6 address <ipv6_addr/prefix> [eui-64] [link-local]
configure interface loopback <0-15> ipv6 address [<ipv6_addr/prefix>] [eui-64] [link-local] no
Supplemental
Information
To remove the IPv6 address identified in the command from the interface, use the no option.
Parameters
<0-15>
The Loopback interface number. Valid range is 0 to 15.
<ipv6_addr/prefix>
Address of interface
[eui-64]
Configures site-local and global IPv6 addresses with an interface identifier (ID) in the low-order 64 bits of the IPv6 address.
[link-local]
Overrides the automatically generated EUI-64 link local address