Chapter 16: Dynamic Routing Protocols
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 541
1. Select the next network to receive an outbound update.
2. Check which interface it is being sent out on.
3. Is there a distribute list applied to that interface?
Yes: Is the network denied by that list?
o Yes: the network does not go out; return to step 1.
o No: the network goes out; continue to step 4.
No: Go to step 4.
4. Check the routing process from which we derive the route.
5. Is there a distribute list applied to that process?
Yes: Is the network denied by that list?
o Yes: the network does not go out; return to step 1.
o No: the network goes out; continue to step 6.
No: Go to step 6.
6. Is there a global distribute list?
Yes: Is the network denied by that list?
o Yes: the network does not go out; return to step 1.
o No: the network goes out; return to step 1.
No: The network makes it; go to step 1.
Distance Configure Commands
To change the static route administrative distance, use the following commands:
configure router static distance <int>
configure router static no distance
Where: int is an integer 1-255 = administrative distance range
To Next Page
Loading...
