Arris C4C - Configure Interface Tengigabitethernet Ipv6 Ospf Transmit-Delay

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2041
configure interface tengigabitethernet * ipv6 ospf transmit-delay
Purpose
Sets the estimated time it takes to transmit a link state update packet on the interface.
Default Access Level
15
Command Syntax
configure interface tengigabitethernet <slot>/<port>[.<0-254>] ipv6 ospf transmit-delay <1-1800>
configure interface tengigabitethernet <slot>/<port>[.<0-254>] ipv6 ospf transmit-delay [<1-1800>] no
Supplemental
Information
To return to the default value, use the no option.
Parameters
<slot>/<port>[.<0-
254>]
RCM slot number/tengigabitEthernet port number[.subinterface number].
Valid range for the C4 CMTS is <17-18>/<10>[.<0-254>]
Valid range for the C4c CMTS is <17>/<10>[.<0-254>]
<1-1800>
Seconds required to transmit a link state update.