EasyManua.ls Logo

Arris C4C - To Configure ISIS on SYS-2

Arris C4C
3180 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 23: IPv6
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 741
2. Configure the IS-IS circuit:
configure interface ethernet 6/2.0 ipv6 address 2001:cada:c422:1702::2/64
configure interface ethernet 6/2.0 ipv6 router isis
configure interface ethernet 6/2.0 isis protocol no shutdown
3. Configure a static null route for the aggregated range of the PD:
configure ipv6 route fc0d:c422:ffff::/48 null 0
4. Configure access list to deny redistribution of a range of PD routes that should not get advertised individually (also
known as prefixes for residential customers):
configure ipv6 access-list list1 deny fc0d:c422:ffff::/48
configure ipv6 access-list list1 permit any
5. Configure the redistributing routes in ISIS. The PD routes for the static commercial range should appear as IS-IS LSP.
The static route for the aggregated range should appear as one IS-IS LSP for the entire range (null route).
configure router isis address-family ipv6 distribute-list list1 out pd
configure router isis address-family ipv6 redistribute static level-1
6. The following command line must be identical on all participating C4/c CMTSs. In particular, the metric type and metric
value in this command must be exactly the same for all C4/c CMTSs configured to handle the route collisions that result
from moving the commercial customers from one C4/c CMTS to another.
configure router isis address-family ipv6 redistribute pd level-1
7. Enable IS-IS:
configure router isis shutdown no
8. Enable PDRI (enabled by default):
configure ipv6 pd-route-injection
configure interface cable-mac 1.0 ipv6 pd-route-injection
9. Enable Prefix Stability (enabled by default):
configure ipv6 prefix-stability
The second part of this procedure begins here. It serves to configure the second C4/c CMTS in this example of Prefix
Stability using IS-IS.
To Configure ISIS on SYS-2
1. Configure IS-IS at the node level:
configure router isis is-type level-1
configure router isis net 47.0001.0002.0003.0044.00

Table of Contents

Related product manuals