Arris C4C User Manual

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1729
configure interface gigabitethernet * duplex
Purpose
By default, the RCM gigabitEthernet ports are set to auto-negotiate. This command sets the operating mode to full duplex, half
duplex or auto negotiate.
Default Access Level
15
Command Syntax
configure interface gigabitethernet <slot>/<port>[.<0-254>] <full | half | auto> duplex
Supplemental
Information
N/A
Parameters
<slot>/<port>[.<0-
254>]
RCM slot number/gigabitEthernet port number[.subinterface number]
Valid range for the C4 CMTS is <17-18>/<0-9>[.<0-254>]
Valid range for the C4c CMTS is <17>/<0-9>[.<0-254>]
<full | half | auto>
Sets the duplex mode to full duplex, half duplex or auto-negotiate. The RCM gigabitEthernet port is set to auto-negotiate.

Arris C4C Specifications

General

Brand	Arris
Model	C4C
Category	Control Unit
Language	English