Arris C4C - Configure Cable Load-Balance Rule Channel-Weight

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1349
configure cable load-balance rule * channel-weight
Purpose
Assigns a rule to the specified load-balance policy.
Default Access Level
15
Command Syntax
configure cable load-balance rule <1-4294967295> channel-weight <equal | US-only | DS-only | US+ | DS+>
configure cable load-balance rule <1-4294967295> channel-weight [<equal | US-only | DS-only | US+ |
DS+>] no
Supplemental
Information
To delete a rule from an existing policy, use the no option.
Parameters
<1-4294967295>
Rule number
equal
Directs the load balancer to use DS and US channel load equally
US-only
Directs the load balancer to use only US channel load.
DS-only
Directs the load balancer to use DS channel load
US+
Directs the load balancer to use double US channel load over DS channel load
DS+
Directs the load balancer to use double DS channel load over US channel load.
Related Commands
configure cable load-balance policy (page 1346)