Chapter 31: Load Balancing
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 925
Is not in multiple receive channel mode (i.e. no service flows bonded across multiple downstreams), unless rule type is
bonded.
The modem’s load balance priority is zero.
Is not running on battery power.
The modem’s MD-CM-SG ID is not zero (as the result of a recent topology change).
Movable CLI Commands
The following CLI commands can be used to show the state of movable or non-movable modems.
show cable load-balance movable [slot<slot_num>] [group <group_id> [detail]]
show cable load-balance notmovable [slot<slot_num>] [group <group_id> [detail]]
Sample output:
show cable load-balance movable
Load Balance Group US Movable
Status ID S/CCH CMs via DCC
----------------------- -------- -----------
0x1000800 (16779264 ) 6/0 1
0x1000800 (16779264 ) 6/1 1
0x1000800 (16779264 ) 6/2 1
0x1000800 (16779264 ) 6/3 1
0x1001000 (16781312 ) 6/0 0
0x1001000 (16781312 ) 6/1 0
0x1001000 (16781312 ) 6/2 0
0x1001000 (16781312 ) 6/3 0
Load Balance Group Movable
Status ID Channel Set CMs via DBC
----------------------- ------------- -----------
0x1000800 (16779264 ) DS 0x01000001 3
0x1000800 (16779264 ) DS 0x01000002 1
0x1000800 (16779264 ) US 0x01000001 4
To Next Page
Loading...
