Arris C4C - Configure Packetcable Eventmsg Retry Limit

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2216
configure packetcable eventmsg retry limit
Purpose
Provisions the event message retry count.
Default Access Level
15
Command Syntax
configure packetcable eventmsg retry limit <count>
Supplemental
Information
This count is the maximum number of times that the Event Messaging Retry Interval may expire before the CMTS will switch to the
secondary RKS.
Note: The CMTS uses the static port 1813 for Event Messages. The CMTS listens to port 1813 all the time. When it sends a message
to an RKS at whatever destination IP and port, port 1813 shows up as the source port in the UDP header.
Parameters
<count>
Maximum number of times the CMTS will try to send the message. The default value is 1. The count range is 0 - 9.