Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2004
configure interface tengigabitethernet * ip rip authentication key
Sets the authentication key.
configure interf
ace tengigabitethernet <s
lot>/<po
rt>[.<0-254>] ip r
ip authentication key <ke
ychain1>
configure interf
ace tengigabitethernet <s
lot>/<port>[.<0
-254>] ip r
ip authentication key [<k
eychain1>]
no
Every RIP message sent on this interface will contain this key and every incoming message received will be validated based on it
having this key.
Note: All commands that include key-chains required that the key-chain already exists before the command is executed. In addition,
the key-chain should not be deleted until after the command(s) that reference it have been reset with the "no" command.
To reset the authentication key, use the no option.
Parameters
RCM slot number/tengigabitEthernet port number[.subinterface number].
Valid range for the C4 CMTS is <17-18>/<10>[.<0-254>]
Valid range for the C4c CMTS is <17>/<10>[.<0-254>]
A 1-16 character text string used for authentication.
To Next Page
Loading...
Need help?
General
