Arris C4C - Set IP Precedence Values

Chapter 16: Dynamic Routing Protocols
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 548
ToS Value | name
Description
1 | min-monetary-cost
Sets the min-monetary-cost ToS
2 | max-reliability
Sets the max reliable ToS
4 | max-throughput
Sets the max throughput ToS
8 | min-delay
Sets the min delay ToS
The ToS value for DOCSIS classification is not supported.
Set IP Precedence Values
The configure route-map-policy * permit * set ip precedence [number | name] route map configuration
command enables you to set the three IP precedence bits in the IP packet header. With three bits, you have eight possible
values for the IP precedence; values 0 through 7 are defined.
Table 71. Setting IP Precedence Values
Precedence Value| name
Description
0 | routine
Sets the routine precedence
1 | priority
Sets the priority precedence
2 | immediate
Sets the immediate precedence
3 | flash
Sets the flash precedence
4 | flash-override
Sets the Flash override precedence
5 | critical
Sets the critical precedence
6 | internet
Sets the internetwork control
precedence
7 | network
Sets the network precedence