Arris C4C - Configure Line Console

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2173
configure line console
Purpose
Configures a console line.
Default Access Level
15
Command Syntax
configure line console <0-1> [<0-1>] [session-timeout <int>] [idle-timeout <int>] [length <int>]
[password <word>] [speed <int>] [authentication <word>] [login-authentication] [enable-authentication]
[authorization <word>] [width <int>] [connect <active | local>]
configure line console <0-1> [<0-1>] [session-timeout <int>] [idle-timeout <int>] [length <int>]
[password <word>] [speed <int>] [authentication <word>] [login-authentication] [enable-authentication]
[authorization <word>] [width <int>] [connect <active | local>] no
Supplemental
Information
The CLI will accept 0 or 1 for the console port. However, the command will set the value for both 0 and 1. It is not possible to set the
two consoles with different values.
To remove or disable a console, use the no option
Parameters
<0-1>
Line number
<0-1>
Integer identifying last line number of a range of line numbers
[session-timeout
<int>]
Session length in seconds. The C4 CMTS automatically terminates the session when this interval expires. A value of zero indicates
no timeout.
[idle-timeout <int>]
Maximum idle time in seconds. The C4 CMTS automatically terminates the session if no I/O activity occurs within this interval. A
value of zero indicates no timeout.
[length <int>]
Page length in number of lines. A value of 0 will disable paged output.
[password <word>]
Line password
[speed <int>]
Baud rate in bits per second. Valid range is 9600 to 115200
[authentication
<word>]
Authentication method list name (up to 16 characters)