Arris C4C - Related CLI Commands

Chapter 14: Cable-side Configuration
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 402
Related CLI Commands
For more information on commands see Command Line Descriptions (page 1127).
configure interface cable-mac <mac> cable …
annex
Configures the MAC MPEG framing format. Annex A (EuroDOCSIS) is used
primarily in Europe; Annex B (DOCSIS) is used primarily in North America and
Japan.
bundle
Configures a cable interface bundle group.
cm-ip-prov-mode
Configures the CM IP provisioning for the interface.
cm-status enabled
Enables signaling of CM-status event reporting mechanism.
dhcp-giaddr
Configures DHCP giaddr mode.
downstream-bonding-group
Configures static downstream bonding group for the system.
dynamic-rcc
Enables/disables the autonomous creation of dynamic RCCs.
dynamic secret
Configures the dynamic secret for tftp enforcement.
freq-ds-max
Configures maximum downstream center frequency
freq-ds-min
Configures minimum downstream center frequency.
freq-us-max
Configures maximum upstream center frequency.
helper-address
DHCP server IP address.
insertion-interval
Provisions the cable MAC insertion interval.
invited-ranging-attempts
Provisions the cable MAC invited ranging attempts.
load-balance
Creates a restricted load-balance group for DOCSIS 3.0 interfaces.
mcast-fwd-by-dsid
Enables the CMTS to use IP Multicast DSID Forwarding (MDF)
mdd-interval
Configures the interval for the insertion of MDD messages.