Arris C4C - Assign Upstream Channels to Fiber Node; Assign Downstream Channels to Fiber Node

Chapter 14: Cable-side Configuration
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 414
Description
Command
Use the [no] option to remove an upstream channel
from the fiber node.
Assign Upstream Channels to Fiber Node
The following command examples assign upstream channels to a fiber node:
configure cable fiber-node FN1 cable-upstream 3/0
configure cable fiber-node FN1 cable-upstream 3/1
configure cable fiber-node FN1 cable-upstream 3/2
configure cable fiber-node FN2 cable-upstream 3/3
configure cable fiber-node FN2 cable-upstream 3/4
configure cable fiber-node FN2 cable-upstream 3/5
configure cable fiber-node FN3 cable-upstream 3/6
configure cable fiber-node FN3 cable-upstream 3/7
configure cable fiber-node FN3 cable-upstream 3/8
configure cable fiber-node FN4 cable-upstream 3/9
configure cable fiber-node FN4 cable-upstream 3/10
configure cable fiber-node FN4 cable-upstream 3/11
It is not necessary to use a separate command for each channel that you assign to a fiber node. You can add several
channels on one command line, shown as follows:
configure cable fiber-node FN3 cable-upstream 3/6-8
configure cable fiber-node FN4 cable-upstream 3/9,11
Assign Downstream Channels to Fiber Node
The following command examples assign downstream channels to a fiber node:
configure cable fiber-node FN1 cable-downstream 12/0 12/1 12/2 12/3
configure cable fiber-node FN1 cable-downstream 12/4
configure cable fiber-node FN1 cable-downstream 12/5
configure cable fiber-node FN1 cable-downstream 12/6
configure cable fiber-node FN2 cable-downstream 12/7
configure cable fiber-node FN2 cable-downstream 12/8
configure cable fiber-node FN2 cable-downstream 12/9
configure cable fiber-node FN3 cable-downstream 12/10
configure cable fiber-node FN3 cable-downstream 12/11