Arris C4C - Show Interface Utilization

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2818
show interface utilization
Purpose
Samples the data rate on a specified interface over a specified (or default) interval and then displays the bandwidth utilization as a
percentage of that interface’s total capacity.
Default Access Level
1
Command Syntax
show interface utilization [min-loaded <1-100>] [slot <0-20>]
Supplemental
Information
Note: You must set the utilization interval to a non-zero value for the utilization to be calculated. Use the following command to set
the utilization interval: configure cable load-interval <interval>
Parameters
[min-loaded <1-
100<]
Displays only ports that meet or exceed minimum percent loaded.
[slot <0-20>]
The chassis slot in which the targeted module resides.
Related Commands
configure cable metering (page 1369)