Arris C4C - Configure Interface Gigabitethernet Isis Authentication Mode

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1815
configure interface gigabitethernet * isis authentication mode
Purpose
Configures the IS-IS authentication mode for LSPs.
Default Access Level
15
Command Syntax
configure interface gigabitethernet <slot>/<port>[.<0-254>] isis authentication mode <md5 | text>
[<level-1 | level-2>]
configure interface gigabitethernet <slot>/<port>[.<0-254>] isis authentication mode <md5 | text>
[<level-1 | level-2>] no
Supplemental
Information
To reset the circuit type, use the no option.
Parameters
<slot>/<port>[.<0-
254>]
RCM slot number/gigabitEthernet port number[.subinterface number].
Valid range for the C4 CMTS is <17-18>/<0-9>[.<0-254>]
Valid range for the C4c CMTS is <17>/<0-9>[.<0-254>]
<md5 | text>
Choose either md5 or plain text
[<level-1 | level-2>]
Specifies the type of adjacencies to be formed on this interface. Valid range is level-1 or level-2.