Arris C4C - Configure Access-List 1-99;Name

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1219
configure access-list {<1-99 | name>}
Purpose
This command is used to configure Access Control Lists (ACLs). It will define a standard ACL to permit or deny traffic destined for the
SCM only. Traffic will be filtered base on source IP addresses only.
Default Access Level
15
Command Syntax
configure access-list {<1-99> | <name>} <1-2147483647> <permit | deny | remark | resequence> [<ip_addr>
[mask] | any | host <ip_addr | any>]
configure access-list {<1-99> | <name>} <1-2147483647> <permit | deny | remark | resequence> [<ip_addr>
[mask] | any | host <ip_addr | any>] no