Arris C4C - Configure Route-Map-Policy Permit Set Ip Next-Hop

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2318
configure route-map-policy * permit * set ip next-hop
Purpose
Configures where to output packets that match the route-map.
Default Access Level
15
Command Syntax
configure route-map-policy <name> permit <int> set ip next-hop <word>
configure route-map-policy <name> permit <int> set ip next-hop <word> no
Supplemental
Information
To return to the default setting, use the no option.
Parameters
<name>
Name of this route-map
<int>
Sequence number
<word>
IPv4 or IPv6 address.