Arris C4C - Configure Cable Submgmt Default Filter-Group

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1440
configure cable submgmt default filter-group
Purpose
Configures the specified filter group.
Default Access Level
15
Command Syntax
configure cable submgmt default filter-group [cm <upstream | downstream>] [host <upstream | downstream>]
[cpe <upstream | downstream>] [mta <upstream | downstream]> [ps <upstream | downstream>] [stb <upstream
| downstream>] <group-id>
configure cable submgmt default filter-group [cm <upstream | downstream>] [host <upstream | downstream>]
[cpe <upstream | downstream>] [mta <upstream | downstream]> [ps <upstream | downstream>] [stb <upstream
| downstream>] [group-id] no
Supplemental
Information
To delete a specific filter group, use the no option.
Parameters
[cm <upstream | downstream>]
Filters on either the specified upstream or downstream CM group defaults
<host <upstream | downstream>]
Filters on either the specified upstream or downstream CPE, MTA, PS, and STB group defaults
<cpe <upstream | downstream>]
Filters on either the specified upstream or downstream regular CPE group defaults
<mta <upstream | downstream>]
Filters on either the specified upstream or downstream PacketCable MTA group defaults
<ps <upstream | downstream>]
Filters on either the specified upstream or downstream CableHome PS group defaults
<stb <upstream | downstream>]
Filters on either the specified upstream or downstream DSG STB group defaults
<group-id>
The filter group ID. Range is 1 - 1023.