Chapter 16: Dynamic Routing Protocols
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 526
Verify that the default metric is changed to match the value entered:
show ip rip
The output should look similar to the following:
VRF Status
default enabled
RIP Interfaces
Interface VRF Df Met Auth Mode State
10.62.1.2 default 0 text active
RIP Timers
VRF default: Update interval is set to 30 seconds.
VRF default: Route invalidation interval is set to 180 seconds.
VRF default: Route flush interval is set to 120 seconds.
Plain Text Authentication
Plain text authentication may be enabled for each active or passive interface running RIP in order to add security to RIP
communication. By default it is disabled on each interface.
The following plain text authentication tasks, along with their associated commands are grouped for convenience. This is
not intended to be a step-by-step procedure.
Enabling Plain Text Authentication
Enter the following command to enable plain text authentication for a given interface:
configure interf
ace {cable-ma
c <mac> | gigabitethernet
<slot>/<port>
| tengigabitetherne
t
<slot>/<port>} ip rip authentication mode text
gigabitethernet
<slot>/<port>
| tengigabitethern
et <slot>/<port>
is the RCM slot number/port number of the specified
interface
The system will respond:
Authentication mode is plain text
To Next Page
Loading...
Need help?
General
