Arris C4C - Configure Interface Cable-Mac;Ip Access-Group

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1591
configure interface cable-mac * ip access-group
Purpose
Sets the access control for packets on the specified interface.
Default Access Level
15
Command Syntax
configure interface cable-mac <mac> ip access-group <list> {in | out}
configure interface cable-mac <mac> ip access-group <list> {in | out} no
Supplemental
Information
To remove the access control, use the no option.
Parameters
<mac>
The MAC identifier. Valid numbers are 0-415.
<list>
Number or name of a standard or extended IP access list. Valid ranges for IP access lists are: standard = 1-99.
{in | out}
Inbound packets or outbound packets
Related Commands
configure interface cable-mac * ipv6 traffic-filter (page 1674)