To Next Page

To Previous Page

Chapter 46: Command Line Descriptions

STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide

configure interface tengigabitethernet * ipv6 nd other-config-flag

Purpose

Sets the ‘other stateful configuration’ flag in IPVv6 router advertisements on the specified interface.

Default Access Level

Command Syntax

configure interface tengigabitethernet <slot>/<port>[.<0-254>]ipv6 nd other-config-flag

configure interface tengigabitethernet <slot>/<port>[.<0-254>] ipv6 nd other-config-flag no

Supplemental

Information

If the flag is set, this means that the CMs and CPE devices should use DHCPv6 to obtain information other than IPv6 addresses.

To restore the default setting, use the no option.

Parameters

<slot>/<port>[.<0-

254>]

RCM slot number/tengigabitEthernet port number[.subinterface number].

Valid range for the C4 CMTS is <17-18>/<10>[.<0-254>]

Valid range for the C4c CMTS is <17>/<10>[.<0-254>]

Arris C4C User Manual

Questions and Answers: