Arris C4C - Configure Interface Gigabitethernet Ipv6 Ospf Network

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1808
configure interface gigabitethernet * ipv6 ospf network
Purpose
Configures the OSPF network type to a type other than the default for a given media.
Default Access Level
15
Command Syntax
configure interface gigabitethernet <slot>/<port>[.<0-254>] ipv6 ospf network <type>
configure interface gigabitethernet <slot>/<port>[.<0-254>] ipv6 ospf network [<type>] no
Supplemental
Information
To return to the default, use the no option.
Parameters
<slot>/<port>[.<0-
254>]
RCM slot number/gigabitEthernet port number[.subinterface number].
Valid range for the C4 CMTS is <17-18>/<0-9>[.<0-254>]
Valid range for the C4c CMTS is <17>/<0-9>[.<0-254>]
<type>
Network type. Current type supported is broadcast or point-to-point.