Arris C4C - Configure Interface Gigabitethernet Flowcontrol Receive

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1732
configure interface gigabitethernet * flowcontrol receive
Purpose
Sets the parameters to receive flow control information.
Default Access Level
15
Command Syntax
configure interface gigabitethernet <slot/port> flowcontrol receive <desired | on | off>
configure interface gigabitethernet <slot/port> flowcontrol receive no
Supplemental
Information
N/A
Parameters
<slot>/port>
RCM slot number/gigabitEthernet port number.
Valid range for the C4 CMTS is <17-18>/<0-9>
Valid range for the C4c CMTS is <17>/<0-9>
desired
Directs that an auto negotiation of flow control take place with preference to process Pause frames (The port will process flow
control if the far end supports/sends it).
on
Directs the specified port to be enabled to process flow control.
off
Directs the specified port to be disabled from processing flow control to the far end.