Arris C4C - Configure Packetcable Eventmsg Element-ID

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2214
configure packetcable eventmsg element-id
Purpose
Configures the Element ID to enable event messaging.
Default Access Level
15
Command Syntax
configure packetcable eventmsg element-id <id>
configure packetcable eventmsg element-id <id> no
Supplemental
Information
This is a number that is assigned to the CMTS that will be included in all event messages from the CMTS. This number is used by the
RKS so that it knows that the event message came from this CMTS. The Element ID must be configured before Event Messages are
generated.
Note: The CMTS uses the static port 1813 for Event Messages. The CMTS listens to port 1813 all the time. When it sends a message
to an RKS at whatever destination IP and port, port 1813 shows up as the source port in the UDP header.
To disable event messaging, use the no option.
Parameters
<id>
There is no default value. This number must be configured for event messaging to work. The range is 0 to 99999.